CCNA Brain Dumps

Question No. 1

You have been asked to evaluate how EIGRP is functioning in a customer network.

What type of route filtering is occurring on R6

• A. Distribute-list using an ACL
• B. Distribute-list using a prefix-list
• C. Distribute-list using a route-map
• D. An ACL using a distance of 255

Question No. 2

Which command will display all the EIGRP feasible successor routes known to a router?

• A. show ip routes
• B. show ip eigrp summary
• C. show ip eigrp topology
• D. show ip eigrp adjacencies

Question No. 3

Refer to the exhibit.

The network setup is running the RIP routing protocol. Which two events will occur following link failure between R2 and R3?

• A. R2 will not send any advertisements and will remove route 192.168.2.0/27 from its routing table.
• B. R3 will not any further updates from R2, due to the split-horizon prevention mechanism.
• C. After communication fails and after the hold-down timer expires, R1 will remove the 192.168.20/27 route from its routing table.
• D. After will reply to R2 with the advertisement for network 192.168.2.0/27 with a hop count of 16.
• E. R2 will advertise network 192.168.2.0/27 with a hop count of 16 to R1.

Question No. 4

Which two values do you use to configure a threshold for an object track list? (Choose two)

• A. weight
• B. metric
• C. priority
• D. queue limit
• E. percentage

Question No. 5

Which location within the network is preferred when using a dedicated router for Cisco IP SLA operations?

• A. user edge
• B. provider edge
• C. access edge
• D. distribution edge

Question No. 6

Which statements best describes the following two OSPF commands, which are used to summarize routes?

area 0 range 192.168.110.0 255.255.0.0

summary-address 192.168.110.0 255.255.0.0

• A. The area range command defines the area where the network resides. The summary-address command
• B. The area range command defines the area where the network resides. The summary-address command
• C. The area range command specifies the area where the subnet resides and summarizes it to other areas.
• D. The area range command summarizes subnets for a specific area. The summary-address commandsummaries a subnet for all areas