Try Updated Cisco 300-360 Exam Questions – [Dec-2017 Dumps]

The success in Cisco Certified Network Professional Wireless 300-360 certification exam is very easy . Your success will give you a lot more in form of your professional development in Network Services,Wireless Network Solutions and Cisco Wireless Networking. The Cisco 300-360 exam practice test software comes with money back guarantee, if you fail in the 300-360 exam, you will not be at risk of losing your money at all. We at, CCNABraindumps provide you most latest and actual 300-360 exam questions.

300-360 exam questions, 300-360 PDF dumps; 300-360 exam dumps:: (83 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-360 Dumps Exam Questions and Answers:

Version: 9.0
Question: 21

What protocol can be enabled to listen in on IPv4 multicast streams and maintain a map of what each client requests on a wireless LAN controller?


Answer: A

Question: 22

A customer reports that wireless clients are not able to receive multicast data from known working multicast servers on the wired network. The client is connecting at the highest mandatory wireless rate of 24 Mbps and the wireless controller is configured for multicast-unicast mode. What three actions should the engineer take next to troubleshoot the issue? (Choose three.)

A. verify that the L3 interfaces are configured for pim sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN
B. change the wireless controller from Multicast-Unicast mode to Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
C. verify that IGMP snooping is disabled on the wireless controller since the access points are handling IGMP messages from the clients
D. verify that Global Multicast mode has been enabled
E. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
F. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows

Answer: A,B,D

Question: 23

New Updated 300-360 Exam Questions 300-360 PDF dumps 300-360 practice exam dumps:

An engineer is preparing for an indoor wireless LAN survey and is provisioning a survey kit. Which three pieces of equipment should be included? (Choose three.)

A. external connector access point
B. integrated antenna access point
C. coax low-loss cable
D. battery operated power supply
E. range finder
F. Yagi antennas

Answer: BDE

Question: 24

Which three options are benefits of U-APSD? (Choose three.)

A. optimized power-save mode periods
B. increased call capacity
C. bandwidth reservation
D. synchronization of the transmission and reception of voice frames
E. efficient roaming
F. priority bandwidth and polling

Answer: ABD

Unscheduled automatic power-save delivery (U-APSD) is a feature that has two key benefits:
The primary benefit of U-APSD is that it allows the voice client to synchronize the transmission and reception of voice frames with the AP, thereby allowing the client to go into power-save mode between the transmission/reception of each voice frame tuple. The WLAN client frame transmission in the access categories supporting U-APSD triggers the AP to send any data frames queued for that WLAN client in that AC. A U-APSD client remains listening to the AP until it receives a frame from the AP with an end-of-service period (EOSP) bit set. This tells the client that it can now go back into its power-save mode. This triggering mechanism is considered a more efficient use of client power than the regular listening for beacons method, at a period controlled by the delivery traffic indication map (DTIM) interval, because the latency and jitter requirements of voice are such that a WVoIP client would either not be in power-save mode during a call, resulting in reduced talk times, or would use a short DTIM interval, resulting in reduced standby times. The use of U-APSD allows the use of long DTIM intervals to maximize standby time without sacrificing call quality. The U-APSD feature can be applied individually across access categories, allowing U-APSD can be applied to the voice ACs in the AP, but the other ACs still use the standard power save feature.
The secondary benefit of this feature is increased call capacity. The coupling of transmission buffered data frames from the AP with the triggering data frame from the WLAN client allows the frames from the AP to be sent without the accompanying interframe spacing and random backoff, thereby reducing the contention experience by call.
Reference: vowlan_ch2.html#wp1045982

Question: 25

A customer has restricted the AP and antenna combinations for a design to be limited to one model integrated antenna AP for carpeted spaces and one model external antenna AP, with high gain antennas for industrial, maintenance, or storage areas. When moving between a carpeted area to an industrial area, the engineer forgets to change survey devices and surveys several APs. Which option is the best to reduce the negative impact of the design?

A. Deploy the specified access points per area type.
B. Resurvey and adjust the design.
C. Increase the Tx power on incorrectly surveyed access points.
D. Deploy unsurveyed access points to the design.

Answer: B

Question: 26

An engineer is performing a predictive wireless design for a carpeted office space, which requires voice capability and location services. Which two requirements are inputs to the design? (Choose two.)

A. overlapping -67 dBm coverage from three access points
B. overlapping -75 dBm coverage from three access points
C. overlapping-72 dBm coverage from two access points
D. continuous -67 dBm coverage from one access pointE. continuous -72 dBm coverage from one access point

Answer: BD ch3_WLAN.html#pgfId-1000250